Central Machinery (Harbor Freight) 1" x 30" Belt Sander Table

Central Machinery (Harbor Freight) 1" x 30" Belt Sander Table

Harry A.
Attaches to the tiny tab the manufacturer provides as a table for an additional 3" in front and to each side of belt for greater ease of use. Cut here from 0.75" MDF with toolpaths in Aspire and dog-ears on inner pocket corners. Attached with 1/4" bolts, washers, and nuts. Check your drive wheel (inside bottom and attached to motor) and swap product under it's 90 day warranty if it or idlers are grossly out-of-round. Toss tiny washer provided for table bolt and use a 1/4" flat washer on each side before mount breaks. Check that platen behind belt is parallel to belt and adjusted properly. Cutting grille from dust port improves air flow if vacuum is attached. Secure table set screw with silicone or superglue. Toss included belt and any others purchased at HF and get good ones. #belt_sander #central_machinery #harbor_freight #sander #table
Default Title