A door that is meant for 4" walls.
....The reason for the extra rectangle is the following (directions)
1) Place the spare rectangle where you wish the door to be
2) take the Push or Pull tool and set the rectangle back to its offset limit.
3) You'll now have a gaping hole where the wall used to be
4) now take you door and place it with the move took over the hole (using an Endpoint for your guide)
5) I have kept the two lines at the left and right sides, top so you know where the 4inches end and begin.
6) Do with it what you will.
:] Thanks #4_inches #Door #Wall