Doll Changing Table

Doll Changing Table

Luke
It's intended to fit Bitty Baby sized dolls. 18" I think. I planed all wood to 5/8", used a router setup to mortise each joint and 1/4" hardboard pieces for the tenons. I used a 6mm upcut bit instead of a 1/4". Fit was tight but worked very well. 1/4" bit would have obviously worked too, but more play in the joint than i wanted. There are no screws of any type in this piece. I wanted to keep it all wood just to be able to say it. Downside is you have to clamp and wait for the glue to cure each time. For doll furniture, it's pretty nice i think. I made 3 at the same time. Used oak because it's what i had on hand and didn't have to buy additional. I'll paint one (sadly), stain one and leave the other natural I think. Have fun #american #baby #bitty #changing #girl #oak #table
Default Title