A set of labelled ruler marks in inches and cm/mm, separately for:
0-6in, Left to right
0-6in, Right to left
0-15cm, Left to right
0-15cm, Right to left
and each in two versions: text above ruler marks, and text below.
The ruler baseline can be turned on or off by the Baseline layer.
Additionally, for UK use, there are dashed lines at the the width and thickness of common timber softwood Planed All Round (PAR), also turned on or off by the PAR marks layer.
For best results, print in Vector mode, using a fine line width - 0.25 or 0.5pts. However, the PAR marks lines, being dashed guidelines, will not print in this mode.
If printing using Raster mode, set Profile edges off, or to no more than 2px.
The text was generated using the free plugin FlatText Lite, and if you install this plugin, can be edited by selecting a text group (embedded inside a component for each separate scale value), the R-click and select Revise FlatText
#150mm #6_inches #ruler #Scale