This is small vertical axis wind turbine optimised for 3D printing. You can print it on ordinary Prisa i3.
This Project was tested on Prusa i3 printer with 1mm nozzle and works really fine even with low wind.
To assembly this VAWT you need:
10 x rounded neodymium magnets 8x10mm
Copper wire - about 140-150 rounds of wire per coil for 48V
2 ball bearings
One nut and screw
Power of this generator depends on what magnets and wires will you use.
Enjoy testing :)
#3d_printable #crotor #small_wind_turbine #vawt #vertical_axis_wind_turbine