Plow for Snow Blower

Plow for Snow Blower

hrianhard
This is a notional design for a plow that attaches to a snow blower. I built a 3’ wide plywood pusher blade for my 21” snow blower and so far it works fine. The added width speeds removal and I hope it will also help avoid plugging if we get a wet snow. The model shown allows the blade to be easily attached/detached with only 2 pins and permits it to be angled either left or right if desired. I may get my son the welder to build me one. I downloaded the snow blower model shown, it was created by Big Mac who did a far better job of it than I would have. NOTE: I have since found a commercially available version of this called Slushplow. At about $300 its eems expensive so I’ll continue to use my plywood prototype for now. #snow_blower #snow_plow
Default Title